Rated 4.8 on Trustpilot

Read Reviews

Illustration of a house at night with one lit room powered by a battery while the street lights are out

·

Battery Storage

Can You Add Power-Cut Backup to Your Existing Solar System?

If your solar goes off in a power cut, backup can usually be added. What it takes depends on what you already have. Here are the options for each starting point.

By

Solar Panels London

·

Last reviewed

Usually, yes. Most solar systems switch off in a power cut, and many batteries do too unless backup was wired in at installation. Backup can normally be added later. What it takes depends on what you have now: solar on its own, a battery with no backup wiring, or a hybrid inverter with a backup output that was never connected. The choice is then between backup for a few essential circuits, or a gateway that keeps the whole house connected.

Key points

  • Grid-connected solar switches off in a power cut for safety, so solar on its own gives no backup.

  • Many batteries have a backup output that was never wired in. Connecting it can be a modest job.

  • Some batteries don’t support backup at all, so adding it means new equipment.

  • Backup for selected circuits (often called EPS) is simpler than whole-home backup.

  • Whole-home backup needs a gateway or changeover switch, and output is still limited by the battery and inverter.

  • With some retrofit setups, the panels can’t recharge the battery during a cut.

Why your solar goes off in a power cut

Solar systems connected to the grid are designed to disconnect when the grid fails, so they don’t send electricity into cables engineers may be working on. That’s why a home with solar but no battery has no power in a cut, even on a sunny day. Our guide to what keeps working in a power cut explains how backup works in general.

Starting point 1: solar panels only

You need a battery with backup capability. There are two routes:

  • Replace the inverter with a hybrid that has a backup output, and add a battery. Solis’s S6 Plus hybrids, for example, switch to backup in under 10 milliseconds when a backup circuit is wired. Our Solis guide explains the range.

  • Keep the inverter and add an AC-coupled battery that supports backup. This keeps the existing inverter, but the panels may not be able to recharge the battery during a cut, depending on the equipment.

Our guide to adding a battery to existing solar panels compares the two routes.

Illustration of three starting points: solar only, solar with a battery, and solar with a hybrid inverter

Starting point 2: a battery with no backup wired

Many hybrid inverters and batteries have a backup (EPS) output that wasn’t connected when they were installed. Connecting it usually means:

  • A small separate consumer unit for the circuits you want backed up.

  • Moving those circuits from the main board to the backup board.

  • A changeover arrangement and testing.

If your battery doesn’t have a backup output, the options are to add a gateway that works with it, if the manufacturer offers one, or to replace the battery or inverter with equipment that supports backup. Our guide to replacing a failed home battery covers replacement options.

Illustration of a backup circuit: a small separate consumer unit supplying a few essential circuits from the battery

Starting point 3: you want the whole house backed up

Whole-home backup uses a gateway between the grid supply and your consumer unit. When the grid fails, it isolates the house and lets the battery supply everything behind it. Examples include the Sigen Gateway, used with a Sigenergy SigenStor, and Tesla’s Backup Gateway 2, used with a Powerwall. Our guides to Sigenergy SigenStor and the Tesla Powerwall 3 explain both.

Whole-home doesn’t mean unlimited. What you can run is still limited by the inverter’s output and the energy in the battery.

Request a battery retrofit quotation

Already have solar panels? Send your details and we’ll call you to talk through adding a battery.

We install across London and up to around 50 miles out.

About your system (optional, helps us prepare)

No obligation. We’ll call you back within one working day (Mon–Fri, 9am–5pm). We only use your details to deal with your enquiry. See our privacy policy.

Choosing what to back up

For backup of selected circuits, most people choose:

  • Lighting.

  • The fridge and freezer.

  • Broadband and a few sockets.

  • Heating controls and a gas boiler, if the manufacturer allows it.

Heavy loads such as electric showers, ovens, immersion heaters and EV chargers are usually left off, because they would drain the battery or exceed the backup output.

Will the panels keep charging during a cut?

It depends on the equipment. On many hybrid systems, the panels keep charging the battery while the house is running on backup. On some AC-coupled setups, they don’t, because the existing solar inverter stays switched off. If you want the panels to keep working during a long cut, tell us at the start so we can design for it.

What else to check

  • Earthing. Backup systems need a suitable earthing arrangement when the house is disconnected from the grid. We check this at survey.

  • Network operator. Adding a battery inverter may affect your notification or approval. Our guide to DNO rules and export limits explains this.

  • Feed-in Tariff. If you’re on the scheme, tell your FIT licensee about changes. Our guide to keeping your Feed-in Tariff when you upgrade covers this.

Frequently asked questions

Does my battery already have backup?

It might. Check the inverter or battery manual for an EPS or backup output, and look for a separate small consumer unit near your main board. If you’re not sure, we can check at an inspection.

How long will backup last?

It depends on how much is stored and what you run. A battery running a few essential circuits lasts far longer than one running the whole house. We don’t quote a runtime without knowing your loads.

Can I back up my heat pump or EV charger?

Usually not on a standard backup output, because of the power they draw. Whole-home systems with large outputs can sometimes run them briefly, but they will drain the battery quickly.

Is backup worth it in London?

Power cuts in London are rare and usually short, so for many people backup is peace of mind rather than a necessity. It matters more if you work from home, rely on medical equipment, or simply want the reassurance.

Add backup to your system

Our battery retrofit and solar upgrade service covers adding backup to existing systems. Request a battery retrofit quotation and tell us what you want to keep running.

Request a battery quotation

Whether or not you already have solar panels, send your details and we’ll call you back to talk through the options and arrange a survey.

We install across London and up to around 50 miles out.

No obligation. We’ll call you back within one working day (Mon–Fri, 9am–5pm). We only use your details to deal with your enquiry. See our privacy policy.

Latest Articles

Ready to Start Saving with Solar?

Get your free no-obligation quote today. Our experts will design the perfect system for your home.

Free Home Survey

MCS Certified

Reply in 1 Working Day

© 2026 Solar Panels London. All rights reserved.

SOLAR PANELS LONDON (SPL) LIMITED, registered in England and Wales, company number 14360308. Registered Office, 20 Rosslyn Crescent, Luton, LU3 2AU. SOLAR PANELS LONDON (SPL) LIMITED is an Introducer Appointed Representative of Shermin Finance Limited, FRN 727594, company number 01276121. Registered Office, Homeserve, Cable Drive, Walsall, WS2 7BN. Shermin Finance Limited act as a credit broker and is not a lender. Credit is subject to status and affordability.